E3D SuperVolcano Upgrade Kit- 1.75mm 12v SUPER-STARTER-12V-175

Upgrade your E3D HotEnd with the SuperVolcano for super fast printing, even at high temperatures.

1 x Plated Copper SuperVolcano Heater Block
1 x Thermistor
1 x Thermistor Extension Cable
1 x Silicone Glass Fibre Sleeving
1 x 80W Heater Cartridge 12v
1 x Brass 1mm Nozzle
1 x Thermal Paste
4 x M3 Grub Screws
1 x Hex Key
1 x Mosfet Board
1 x Mosfet Wires


Health and Safety:
The 12V SuperVolcano heater draws up to 8A which is more than most controller boards can handle. Therefore it cannot be used without the included mosfet switch which will handle the high current requirement. Do not use the heater provided with any other block than the SuperVolcano block. Using the heater with another block might result in catastrophic failure of the system. Please note care must be taken when bending the heater cartridge wires and not to bend them to a sharp point as this could snap the wires due to their gauge. Ensure not to fatigue the wires by repeatedly bending them as this will cause failure. The full health and safety information can be found in the datasheet and must be adhered to.