E3D Revo Six - 24V / Fully Loaded Kit REVO-SIX-175-24V-AS-FL

Ready for Revo

No machine redesign. Revo Six is a top choice if you want to update your old E3D V6 setup to the latest generation of E3D HotEnd technology. It has the same height, the same diameter, and the same groove mount as the E3D V6, so it drops straight into V6-fitted machines without the hassle of redesigning print head mounts and accessories. Just fit it, connect the Revo HeaterCore, and you’re ready to 3D print.

Change nozzles at room temperature using just your fingers. No complex tools, no hot tightening. Revo Nozzles are a factory sealed nozzle and heatbreak in one, so they’re easy to fit and can’t leak material when in use.

New hotness. A Revo HeaterCore heats up in seconds. It’s much safer too – unlike other solutions on the market, a positive temperature coefficient (PTC) means the Revo HeaterCore can not melt at extreme temperatures: power reduces as it gets hotter, so hazards are reduced in the event of a thermal runaway.

A new look.

An anodised black heat sink distinguishes Revo Six from its predecessor, and every unit ships with a premium crystal-clear fan duct so your machine will stand out from the crowd.

Please note:

- You may need to adjust your Z offset when changing nozzles.

Key features:

- Max temp: 300°C
- Filament diameter: 1.75mm
- Groove mount
- Voltage: 24V
- Power: 40W

Kit includes:

- 1 x Revo Six heatsink
- 1 x Revo HeaterCore 24V
- 1 x Spring
- 1 x Extension cable kit
- 1 x 100mm PTFE tube
- 1 x 0.25, 0.40, 0.60 & 0.80 Brass Revo Nozzles