E3D v6 HotEnd Full Kit - 1.75mm Direct 24v V6-175-24V

E3D-V6 Hotend, smaller, easier, higher performance

The E3D judgment was redesigned from the ground up. E3D has a lot of time and experience invested for this product Prints the widest panel of materials. With this in mind, it is possible to print flexible filaments in excellent print quality.
With the supplied thermistor, you can reach up to 300 degrees. This judgment is heated in 20 seconds from 20 degrees to 200 degrees. The temperature can be adjusted and held down to 0.5 degrees. The new E3D V6 Hotend is smaller than its predecessors. The total length is only 62mm, The new Thermistor cartridge can be easily attached with a small screw. There is no need for tape, Kapton, fiberglass wire or other mounting tape. By thermal separation, there is much better control over the filament flow. Our range of different nozzle sizes gives you many more possibilities. By default, you get a 0.4 mm nozzle. With this nozzle, you can achieve great prints with a good speed. You can find in our shop various suitable nozzles. The nozzles can change easily thanks to the hexagonal shape.

What`s in the box

• 1 x aluminum heat sink
• 1 x Stainless Steel Heatbreak
• 1 x Brass nozzle 0,4 mm
• 1 x aluminum heating block for thermistor cartridge
• 1 x Thermistor cartridge
• 1 x Silicone Socks
• 1 x 24V 30W heating cartridge
• 1 x 24V 30x30x10mm cooling fan
• 1 x Fan Duct
• All require screws

You can find a setup guide here .