1730 Full Metal Hotend / Standard Edition Basic Set 01900130.0

The 1730 Hotend is completely assembled. You can print 1.75mm or 3mm filament. Just change the nozzle and you can print in the other diameter. You can easily change the nozzles in the cold state. The very short but effective heating range also distinguishes the Hotend manufactured in Holland. Only very high-quality materials were used. Since the makers of the 1730 were aware of the fact that his perfect judgment is to the print quality. Completely made of metal, no PEEK or PTFE has been installed. 500 degrees are possible with an additional upgrade at the thermistor.
 

Nozzle

The nozzle is the centerpiece of the 1730 Fullmetal Hotend and makes 3D printing much easier. The filament nozzle units are made of high quality stainless steel with a brass nozzle tip. The filament nozzle units have an optimal thermal property. It also reduces the friction on the filament. The heat stopper integrieret in the filament nozzle units.
 

What's in the box

• Heating block
• Heatsink
• Immersion heater 40W: 12V

- Thermistor 100K
- Nozzle 1.75mm 0.40mm
- Nozzle 3mm 0.40mm